11
Mid Frequency Driver replacement continued:
1
2
3
4
5
Four screws and locking washers may
be removed from the mid frequency
driver using the phillips head screwdriver.
Contrary to what the picture shows, the
screws are actually about 2
3/4
” down
from the top of the driver. Also note that
the screws may be tighter than usual.
Please DO NOT add WD-40 or any other
lubricant to help loosen the screws.
6
Keep the four screws and locking
washers in a safe place.
7
The mid frequency driver easily lifts right
off of the horn. Replace with the new
driver (part #0013896) and follow the
same steps as above, but backwards 6
to 1. Power up the SR1530z and the new
driver should now be pumping out those
mids again. Right on, you just replaced a
mid frequency driver!
Summary of Contents for SR1530z
Page 1: ...1 SR1530z REPAIR MANUAL...
