SET-UP MID-POINT LIMIT
8. Press UP or DOWN button on the remote to move the blind and press STOP when desired mid-point limit is reached.
9. Press and hold the LIMIT button first then whilst holding LIMIT press UP button on the remote until the motor jogs.
Mid-point is now set.
10.Press STOP to move the blind to Mid-point position.
DELETE ORIGINAL HANDSET ON MOTOR
1. Press and hold SETTING button on the motor mount and the motor
will jog (2-3 times in one motion) and then release the button.
FAQ: If the motor does not work:
• Please charge the motor battery first.
• If the motor does not stop at the required point, then the stops must be reset.
DELETE MID-POINT LIMIT
11. Press UP or DOWN button on the remote to send blind to
upper or lower limit.
12. Press and hold LIMIT button first then whilst holding LIMIT
press UP on the remote until the motor jogs. Mid-point is
now deleted.
Setting button (Red)
1
SET-UP UPPER LIMIT
5. Press UP button on the remote to move the blind up and press
STOP when desired upper limit is reached.
6. Press UP button and the motor will run steps to set the upper
limit accurately.
7. Press CONFIRM button on the remote and the motor will jog 2
times, the upper limit is set.
PLEASE NOTE: The group channel will be recorded on the motor automatically when the single channel has been programmed on the motor.
Cycle through the channels until all the lights are lit to access the group channel on the remote.
5
6
7
8
9
10
11
12
R 1 7 1 0 S A F E T Y I N S T R U C T I O N S
