R4045
Motor Instructions
for use with R4048 Remote Control
Step 1 - Pairing the handset with the motor
Note: During the setting procedure, the time between two operations must not
exceed 4 seconds as this will cause the setting up process to quit.
•
Switch on the power to the motor.
•
Remove the battery cover on the reverse of the remote. There are two setting buttons (P2)
on either side of the battery, press either one.
•
Select a channel from 1 - 15 on the remote by pressing channel up or down (< or >).
•
Press the button on the motor and the motor will jog up and down.
•
Press P2 twice then the up or down button once. The motor will jog twice each time.
•
To change direction press and hold the button on the motor for 4 jogs.
The motor and remote are now paired.
Step 2 - Setting the limits
Select the same channel and set the top limit.
•
Press P2, then the up button followed by P2 again, the motor
will jog twice and beep.
•
Press the up button and the blind will start to rise.
•
Press P2 and the blind will go into slow jog mode.
•
Press the stop button on the remote and the blind will stop.
•
Hold the stop button down until the motor jogs twice, this will set the top limit.
•
Press the down button and the blind will start to go down.
•
Press P2 and the blind will go into slow jog mode.
•
Press the stop button on the remote and the blind will stop.
•
Press and hold the stop button down until the motor jogs twice, this will set
the lower limit.
Setting is complete. For more blinds, select another channel on the remote and repeat from step 2.
1 jog = 1 movement, up OR down
2 jogs = 1 movement, up AND down
Portable 15 Channel Remote Unit
Down button
Channel <
Setting Button
Stop Button
Up Button
LCD
Screen
Channel >
4
