Theory of Operation
LD3SBF
The LD3SBF needs to be manually adjusted for the width and
height of the box to be sealed.
With the machine off, a box will need to be placed between the
side belt arms. Rotate the hand wheel to adjust the side belt drives
out. Raise the head assembly by losing the lock knob on the side
of the head weldment. With the lock knob loose lift the head
assembly till it clears the box then rotate the lock knob to lock the
head in place.
(NOTE: Do not place the box on top or under cartridge
while adjusting drives or head assembly. Damage may
result.)
While holding the box in placed between the side belt drives turn
the hand wheel till the side belt drives grip the box. Fold all four
top flaps of the box, holding them down unlock and then lower
the head assembly till it is just resting on top of the box then lock
the head in place with head lock knob.
Start machine and the box will be pulled through with the side
belt drives and exit the machine. It may be necessary to increase
the side belt drive tension if the box stalls. Rotate the hand wheel
to increase drive pressure.
( NOTE: Excess pressure will cause
box damage and to little will cause box to stall.)
Chapter
5
Summary of Contents for LD3SBF
Page 31: ...ASSEMBLY DRAWINGS AND SCHEMATICS Chapter 10 ...
Page 39: ......
Page 40: ......
