Lovi EXPERT, Instruction Manual

12

WARNING! 

Always disassemble valve membrane (fig. 1k) by catching it with two fingers near the ”hinge” as close as 

possible. Never pull the edges of the membrane, because such operation can damage it and in consequence weaken the 

suction strength. 

WARNING!

 Before each use, check the condition of all elements for cracks, tears, discoloration or deterioration, as they may 

affect the effectiveness of the device.

How to disinfect the teat? 

Before first and subsequent use wash the teat in warm water then place it in boiling water for 5 min. This is to 

ensure hygiene. Inspect carefully before each use. Pull the teat in all directions. Throw away at the first signs 

of damage or weakness. Do not leave the teat in a direct sunlight, close to a source of heat, or in disinfectants 

(sterilizing solution) longer than recommended, as this may weaken the teat. Do not tighten up bottle locking ring, 

as it may disturb its ventilation. Always check for leakage. It is recommended to replace a teat max. after 2 months 

of use to ensure safety and hygiene.

After use, clean the bottle and the teat from food remains, rinse and then disinfect in by placing it steam sterilizer 

or in a hot water. The bottle is dishwasher safe (max. temp.65°C). Do not wash the teat in the dishwasher because 

detergents / cleaning agents can cause damage to the product.

For your child safety and health WARNING! 

Always use this product under adult supervision. Never use 

feeding teats as soothers. Continuous and prolonged suckling of fluids may cause tooth decay. Always check food 

temperature before feeding. Warming in microwave oven may result in locally high temperature. If warming food 

in microwave oven, remember to leave the bottle open. Take particular care when heating in a microwave. Always 

stir heated feed to ensure even distribution of temperature and check liquid temperature before giving it to the 

child. Warming breast milk in microwave is not recommended. This product is not a toy. Keep all components out 

of the reach of children when not in use.

ASSEMBLING INSTRUCTIONS

Place silicone massaging cushion (fig. 1b) in the plastic brace 

(fig.1c). Push the narrow part of the cushion to the narrow 

neck of plastic brace. 

I

mportant! 

Make sure that the edges of cushion fit evenly to the 

edges of plastic funnel. Take a note that the both elements are 

profiled and should be properly matched to each other. 

Silicone cushion can be placed fast and easily in the plastic 

funnel after placing it on dust cover (fig. 1a) which should be 

taken off after assembling.

Holding silicone membrane (fig 1f) in one hand (concave 

side down), put the inner cap stopper (fig 1e) through the 

membrane  so that the wide end of a stopper becomes the 

membrane base while the narrower one will stick up.