Low Cost Mobility 250 GK83, User Manual

9 

Seat Removal

(Fig. 8A

) 

Fold down the back of the seat.  Pull up  
the red swivel seat adjustment lever 

(fig. 

7A

) 

and lift seat off. Remove the hand knob              
and locking pin that secures the seat  
adaptor.  Lift the seat adaptor out of the  
seat post. 
 

(Fig. 8B) 
Remove seat as described (fig 6).  Remove  
battery pack (refer to disassembly section).  
Using two 13mm wrenches, remove locking  
bolt and nut. Adjust seat post up or down to  
desired position. The seat height can be  
adjusted to five different positions by inserting  
the locking bolt in the desired hole.  Replace  
washer and nut and tighten. Replace battery pack  
and seat.  

Armrest Width Adjustments (Fig. 9)                  

On the underside of the seat there are two 
 hand knobs, one either side.  Loosening                          
the hand knob allows the arm rest to be 
 adjusted to the required width, or removed 
 for transportation. 
 

 
DO NOT

 USE SCOOTER WITHOUT THE  

ARM RESTS BEING FITTED & SECURED.

 
Armrest Angle Adjustment (Fig. 10) 

Flip up the armrests to allow access to the        
 adjustment screw and lock nut, unscrew  
the lock nut and screw the bolt in or out 
 to increase or decrease the angle.   
Re-tighten the lock-nut. 
The armrests are set parallel to the floor 
 at the factory. 

Figure 10

        Figure 8A

Seat 
Adaptor

Seat 
Tightening 
Hand 

Seat 
Locking 
Pin 

Figure 9

Armrest 
Adjustment 
Hand Knob

Locking 
Nut and 
Bolt 

Adjustment 
Screw 

Locking 
Bolt 

Seat 
Post 

Adjustment 
Holes

Figure 8B