Lowell UPS8 Series Manual
Pg. 33
Step 4:
Remove the metal top cover of the battery box by unscrewing 8 screws on the sides (4 per side), 3 screws on top,
and 4 screws on back .
Step 5:
Once the battery box is opened, remove the hold down brackets on the left side by unscrewing the 2 screws on each
bracket .
Note:
To install a second string of batteries, repeat the same procedure on the hold down brackets on the right side
of battery box .
Step 6:
Now, it is possible to put all batteries inside the unit by following the drawing below, which indicates wire fastener
positions for correct battery placement .
Note:
To install a second string of batteries, repeat the same procedure on the right
side of battery box .
Step 7:
Connect all batteries following the Wiring Diagram in the next section .
Step 8:
Put all batteries inside and secure in place with hold down brackets .
Note:
To install a second string of batteries,
repeat the same procedure on the right side of battery box .
Step 9:
Replace the metal top cover on the unit . Close the front fixing plate and the two parts of the front panel and secure
with screws .
Step 10:
Connect the battery box to the UPS .