Lowell UPS8 Series Manual
Pg. 32
Step 6:
Now, it is possible to put all batteries inside the unit by following the drawing below, which indicates wire fastener
positions for correct battery placement .
Note:
To install a second string of batteries, repeat the same procedure on the right
side of battery box .
Step 7:
Connect all batteries following the Wiring Diagram in the next section .
Step 8:
Put all batteries inside and secure in place with hold down brackets .
Note:
To install a second string of batteries,
repeat the same procedure on the right side of battery box .
Step 9:
Replace the metal top cover on the unit . Close the front fixing plate and the two parts of the front panel and secure
with screws .
Step 10:
Connect the battery box to the UPS .
MODEL NO. UPS-XBP-72:
Step 1:
Open the package and place the battery box on a horizontal plane .
Step 2:
Remove the left side of the front panel by pulling it from the lower extremity .
Step 3:
Remove the fixed part of the front panel by removing the 2 screws present .
