Operation
Keys
Description
A
Left and Right steering
Anchor mode: moves anchor position 1.5 m (5 ft) left
or right
B
LED
C
Propeller speed Up and Down
Anchor mode: moves anchor position 1.5 m (5 ft)
forward or backward
D
Single press: propeller ON/OFF
Press and hold: activates Anchor mode
Pair and configure the remote
1.
Insert the batteries in the TMR-1
2.
Put TMR-1 into discoverable mode by holding propeller speed Up and Down
(C)
keys at the same time for at least 5 seconds. The LED
(B)
should flash red in 1 second
intervals
3.
Put the trolling motor into user configuration mode by holding the configurable key
2 and configurable key 3 on the pedal until an audible tone is heard and the Power
LEDs start blinking. Next, press and hold the Battery test key. An audible tone will
be heard and the battery status LEDs will start blinking when the trolling motor is in
Bluetooth pairing mode.
4.
Once the LED on the TMR-1 starts blinking in green, press and hold propeller ON/OFF
(D)
key. When the green LED changes to long flashing, TMR-1 is paired to the trolling
motor
5.
Exit configuration mode on the trolling motor (alternatively power cycle the trolling
motor)
TMR-1 can now be used to control the trolling motor.
LED behavior
Color
Behaviour
Status
Red
Slow flashing
Low battery
Fast flashing (1s intervals)
In pairing mode
Flash (on key press)
Not connected
Green
Flash (on key press)
Connected and working
Add/replace batteries
The unit uses 2x AAA batteries.
Remove the cover to add or replace batteries.
A
B
C
D
