7
EZP8
1.
Place the seat upside down on a flat surface.
2.
Place one of the legs in a corner of the seat making sure the mounting holes align.
Fasten the leg to the seat corner using a bolt and spring washer.
Use just your fingers to tighten the bolt at this point. Do not tighten completely with the wrench yet.
3.
Repeat step 2 for the remaining three legs. Again, tighten all bolts only finger tight at this point.
4.
Once all four legs are fastened (finger tight) stand the bench on its legs. When possible you will want
to stand the bench in the location where it will be used. A flat surface is satisfactory.
Press down on the bench and at the same time gently shake it from side to
side to help the parts settle into place. This step helps to achieve a solid
and tight bench.
5.
Once the bench feels stable and secure, carefully turn it upside down again.
Now firmly tighten all four bolts using the wrench provided.
Note:
Repeat Steps 4 and 5 if the bench is not stable.
Please follow these instructions carefully and completely for your safety and comfort. A poorly assembled
bench can cause injury.
CAUTION:
1.
Do not use the bench for any purpose other than its intended use as the EZP8 bench.
2.
Only one person at a time may sit on the bench.
3.
Be sure all bolts are firmly tightened during the final stage of assembly.
4.
Be sure to immediately retighten any bolts that may loosen over time.
Be sure that all parts are included before starting to assem-
ble your EZP8 bench.
PARTS PROVIDED
Seat . . . . . . . . . . . . . . . . .1 pc.
Leg . . . . . . . . . . . . . . . . . .4 pcs.
Bolt . . . . . . . . . . . . . . . . . .4 pcs.
Spring Washer . . . . . . . . . .4 pcs.
Wrench . . . . . . . . . . . . . . .1 pc.
Assembling The EZP8 Bench
Summary of Contents for EZP8 Virtual Orchestra
Page 1: ...Owner s Guide...
Page 3: ...1 EZP8...
Page 4: ...2 Lowrey Virtual Orchestra...
Page 5: ...3 EZP8...