Loxit Limited, First Avenue, Poynton Industrial Estate, Poynton, Cheshire, UK. SK12 1YJ
www.loxit.com ꞁ sales@loxit.com ꞁ +44(0)1625 856 801
Safety
Power Rating:
230v
–
50 Hz
–
10 amps.
TOTAL NOT TO EXCEED 10 amps
. OUTPUT
–
230V AC
–
10 amps.
Fuses located within the plug and Power inlet IEC block are the only user serviceable parts within the
unit, any warranty and service issues should be referred to your supplier.
Power input IEC block fuse: Fast Blow Glass Fuse, 10A, 250V (F10AL250V)
Mains cable plug fuse: 10A BS1362 Fuse
In the event of the mains plug or lead being damaged, the unit should not be used until a new plug or
lead has been fitted by a competent person. The old plug or lead must be safely disposed of.
THE MAINS INPUT TO THE LAPBANK CB CABINET MUST ONLY BE PLUGGED INTO AND REMOVED
FROM A SWITCHED MAINS PLUG SOCKET WHICH IS TURNED OFF.
If any fault or damage is found with any mains input cable, remove all power sources and stop using
immediately. Contact Loxit Limited on +44 (0) 845 519 5191 for a replacement cable.
Visit www.loxit.com for contact details or sales@loxit.com to e-mail.
UNDER NO CIRCUMSTANCES SHOULD REPAIRS BE MADE TO THE MAINS INPUT CABLE.
•
This Laptop storage and charging product must only be used by a competent adult and must not
be used if this can not be assured.
•
If you are in any doubt please refer to your Health and Safety Co-ordinator and/or Health and
Safety Manual for guidance.
•
This product requires PAT testing at maximum 12 monthly intervals.
•
Portable Appliance Testing- This unit must only be earth bond and insulation tested using the IT
settings on any PAT tester.
•
WEEE Directive- When the unit becomes redundant it must be disposed of in compliance with
the WEEE directive 2005.
