About the product
Installed underneath your non-conducting surface (Note the max.
surface thickness of 30mm), the Loxone Touch Surface gives you
the possibility to control your smart home using the Loxone switch
standard.
To prevent accidental use, there is an activation button. Upon touching
this button, the five touch points of the switch are activated for 5 se-
conds, and the remaining time will be displayed through the activation
indicator.
If the activation function is not needed, the activation button can be
reconfigured as necessary in Loxone Config.
Features
• Loxone Switch Standard
• Accidental operation protection
• LED activation indicator
Installation
Installation without activation indicators
If you would prefer not to install the light pipes or mark the surface at all
you can use the provided decal to show the touch points.
Mount the Touch Surface to the underside of the surface. Once powe-
red up, learn-in and configure the Touch Surface using Loxone Config.
Installation with activation indicators
Prepare the surface on which the Touch Surface is to be installed
by drilling 5 holes for the LED indicator lights and marking the touch
points (We strongly recommend that the holes are drilled by a
professional to avoid damage to the surface).
The activation indicator lights need to be installed on the Touch
Surface prior to mounting it.
Mount the Touch Surface to the underside of the surface. To seal the
holes for the activation indicator lights, use a transparent epoxy resin.
It is important to ensure that no dirt or grit is present in the holes or
on the underside of the mounting surface prior to using the resin.
When applying the resin ensure that no air bubbles are created.
Once powered up, learn-in and configure the Touch Surface
using Loxone Config.
Learn Button
Power Supply
Mounting Holes
Status-LED
Mounting Hole
6
5
2
1
3
4
304
115
Touch points
Support film
Decal for touch
surfaces
DOWNLOAD FREE
DXF-TEMPLATE
www.loxone.com/
touch-surface
Light pipes
Activation button
