L-Proxy User Manual
144
LOYTEC
Version 3.1
LOYTEC electronics GmbH
Explanation
If L-Proxy is moved from one LonMaker/NL220/Alex project into a different project
LonMaker/NL220 must release all captured resources in L-Proxy. Resources are released
when the L-Proxy Port is deleted from the LonMaker/NL220/Alex project.
Solution
Select the L-Proxy Port in the old LonMaker/NL220/Alex project and choose
Delete/Remove from the context menue. Make sure that the device can be reached by
LonMaker/NL220/Alex during the deletion process. Therefore LonMaker/NL220/Alex
must be On-Net. This process must be followed for all L-Proxy ports that have been used.
As a second alternative the L-Proxy can be set into its factory default state through the
console interface, see Section 4.8.
12.5 Node does not respond to poll request
Problem
The input NV on the L-Proxy is being polled by another node but L-Proxy does not
respond to the poll message.
Explanation
If the L-Proxy internal connection consists of only one input NV and one or more output
NVs then this input NV cannot be polled by another node. If the internal connection has 2
or more input NVs and the poll is received on the first input NV the poll will be forwarded
on the second input NV.
If the internal connections uses active poll (active poll flag enabled) the input NV that
outputs the active poll (first input NV if multiple input NVs exist) cannot be polled.
Solution
Always poll the source of the information (output NV on source node) and not the input
NV of the L-Proxy.
12.6 L-Proxy doesn’t forward packets after commissioning
Problem
No packets are forwarded by L-Proxy after one or more ports have been re-commissioned.
Explanation
The L-Proxy configuration will be deleted when one or more ports are commissioned.
Solution
Always download the L-Proxy configuration after commissioning one or more L-Proxy
ports.
Summary of Contents for L-Proxy
Page 1: ...L Proxy CEA 709 Gateway User Manual LOYTEC electronics GmbH ...
Page 10: ......
