L-Proxy User Manual
26
LOYTEC
Version 3.1
LOYTEC electronics GmbH
4.4.2 Option 2 – Configure Earth Position
This menu item allows configuring the L-Proxy’s earth position. This setting defines the
longitude, latitude, and absolute altitude of the device. This setting is used for an
astronomical clock. For fixed locations such as a building, the position can be entered in
this menu (see Figure 14). For moving locations, this setting can be updated over the
network using the network variable nciEarthPos (see Section 9.1.2).
Earth Position Configuration Menu
=================================
[1] Set latitude : 48:13:14 N
[2] Set longitude : 16:20:05 E
[3] Set altitude : 200 m
[q] Quit without saving
[x] Exit and save
Please choose:
Figure 14: Configure Earth Position
The latitude and longitude are entered through menu items
2
and
3
as degrees, minutes, and
seconds. The altitude is entered in menu item
3
in meters height above sea level.
4.4.3 Option 7 – FTP server, 8 – FTP server port
This menu option allows enabling and disabling the FTP server and configuring the FTP
server port. Press ‘7’ to toggle between enabled and disabled. Press ‘8
’
to change the FTP
server port. To use the default port, enter ‘0
’
when asked for the port number. The FTP
server can be used to download a data point configuration or update the firmware (see
Section 11.1).
4.4.4 Option 9 – Web server, 0 – Web server port
These menu items allow enabling and disabling the Web server and configuring the Web
server port on the L-Proxy. You can disable the Web server if you do not want to provide
access to the L-Proxy configuration via the Web interface. Press ‘9’ to toggle between
enabled and disabled. Press ‘0’ to change the Web server port. To use the default port,
enter ‘0’ when asked for the port number.
4.4.5 Option a – Telnet server, b – Telnet server port
This menu option allows enabling and disabling the Telnet server and configuring the
Telnet server port. Press ‘a’ to toggle between enabled and disabled. Press ‘b
’
to change the
Telnet server port. To use the default port, enter ‘0
’
when asked for the port number. The
Telnet server is used to connect the Configurator software to the device via IP (see
Section 7.9.2).
4.5 CEA-709 Configuration Menu
This menu allows changing the settings of the CEA-709 port of the L-Proxy. The menu is
only used for displaying information on the L-Proxy. And looks as shown in Figure 15.
CEA-709 Configuration Menu
==========================
Port 1 : FT
Port 2 : FT
IP : IP-852
[q] Quit without saving
[x] Exit and save
Please choose:
Figure 15: CEA-709 Configuration Menu on the L-Proxy.
Summary of Contents for L-Proxy
Page 1: ...L Proxy CEA 709 Gateway User Manual LOYTEC electronics GmbH ...
Page 10: ......