4 | LP Morgan Installation Instructions
LP Morgan Resi-Lift Manual
electrical connections
Unit operates on 220v AC, 50 Hz. current.
The Resi-Lift is shipped closed, with a temporary field connection provided in
the form of a pigtail temporarily wired to the unit. After hanging the unit, make
sure power is off and use this pigtail to temporarily connect the unit to power
and to a switch, so the unit can be lowered to allow access inside.
Please note: Make sure electrical supply has been disconnected before
attempting to connect Resi-Lift to power.
Terminal strip for field connections is located inside the unit on the left (as seen
from front, or non-scissored end). Unit is shipped with internal wiring complete
to the terminal strip. Once the unit has been lowered, turn off power, disconnect
temporary pigtail from unit, then complete permanent wiring to electricity and
to switches. Wire to connect unit to power supply and to switches should be
furnished by installer. Connections should be made in accordance with wiring
diagram, and wiring should comply with national and local electrical codes. All
operating switches should be “off” before power is connected.
Resi-Lift should be operated and checked prior to installing projector and/
or optional ceiling closure.
NOTe:
Resi-Lift is USA made and therefore has imperial dimensions.
