- Instruction Manual for ESS R050096 -
17
(2)
Carry the inverter and holding it, make sure the hanger aim at the expansion bolt, and fix the
inverter on the wall.
(3)
Fasten the screw head of the expansion bolt to finish the mounting.
3.4 Battery system cable connection
Note: This section mainly describes the battery module assembly instructions. If the battery
packs have been installed in the cabinet, you can skip this section.
Note: Before wiring, make sure each battery module is turned off.
3.4.1 Battery modules grounding
Screw one end of the yellow green ground wire (labeled bat / GND) to the ground point of the
battery box panel, and the other end to the frame ground point. Tighten the screw with a
screwdriver.
Picture 3-9 Grounding diagram of battery module