4 0
TREA
TMENT
HEADS
7
→
CLEANING THE ERGODRIVE HEAD
(CONT’D)
FIG. 1
FIG. 3
FIG. 4
FIG. 2
Cleaning the Keymodule:
1.
Turn over the Keymodule and thoroughly clean the following parts for at least one minute
with the LPG wipes soaked in a bactericide and fungicide solution:
a) The housing on both sides of the rollers
(Fig. 1).
b) The rollers (rotate them manually to clean the entire surface)
(Fig. 2)
.
c) The sealing ring between the Keymodule and head housing.
d) The plastic covering on the Keymodule.
2.
Turn the Keymodule again and refit the sealing valves.
3.
Ensure that the the sealing joint between the Keymodule and main head is also cleaned.
4.
Check that the electrical contacts are clean and dry and proceed in the reverse sequence
to refit the Keymodule onto the main head.
5.
Clean the storage drawer using LPG wipes then place the head in it.
