Mode of operation
MultiPress S
Operating manual 3.0
Rev 3.6.2009
35
Curing stage (5)
After its removal, the multilayer must rest at room temperature for at least
16 h, to allow the adhesive to cure completely.
Note:
An incompletely cured adhesive can smear the inner layers during
drilling, thus no longer guaranteeing proper through-hole plating.
5.1.2 Configuration
The MultiPress S is equipped with a permanently configured LPKF press
profile and six freely configurable profiles.
LPKF Set
The press profile
LPKF Set
can be used for standard multilayers
comprising 4,6 and 8 layers of layout 200 x 275 mm (7.87“ x 10.83“)
.
To
guarantee optimum processing at the parameters listed in table 1, the
base material must have a size of 305 x 229 mm (12" x 9").
Variable profiles
The press profiles available for individual configuration
Profile 1
–
Profile 6
have been preset to the parameters listed in table 1. In this way,
depending on the requirements, only few changes must be made.
Tab. 1:
Preset pressing
parameters
Tip:
Write down the parameters that you have changed. The Appendix
contains a table in which you can enter the parameters required for
your applications.
Parameters
LPKF 1
Profile 1
–
Profile 8
Preheating temperature
250 °C
250 °C
Prepressing temperature
180 °C
150 °C
Main pressing temperature
180 °C
180 °C
Prepressing time
10 min
10 min
Main pressing time
60 min
30 min
Prepressing force
80 N/cm²
80 N/cm²
Main pressing force
150 N/cm²
100 N/cm²
Width
305 mm
305 mm
Height
229 mm
229 mm
Summary of Contents for MultiPress S
