Rev.: 13.01.2014
11
User Manual v2.11
saFety notes
4.3
Safety measures
Before operating the device a full visual inspection should be carried out. In the event of any
defects or malfunctions, work may not begin before removing all faults!
It is of vital importance that the area around the device is maintained clean and tidy. A disorganised
workplace can cause occupational injuries (e.g. a person can fall, slip or incur an injury).
Holding bars must always be mounted on the frame during printing.
Do not push sharp edges of the stencil through the notches on the profile.
Do not use air pressure over 6 bars (87 PSI). It can damage the frame permanently. Make sure
to use clean and dry air only. Exceeded air pressure may damage the stencil permanently.
Consider recommended compressed air supply according to the frame type and stencil thickness.
Please ensure, that the environment in which the equipment is going to be used, conforms to
that specified in this document.
While working with the device, complete attention of the operator is required. A person who is
feeling unwell or is having difficulties concentrating should not operate the device!
Only equipment, which has been approved by LPKF, can be used in conjunction with the device.
The use of unsuitable equipment could endanger the operator!
Repairs can only be carried out by authorised service personnel. The service personnel should
ensure that the safety of the equipment is not compromised by the repair.
The storing or consuming of food and beverages in the work area is forbidden!
Smoking in the work area and while working is forbidden!
When using hazardous substances, safety data sheet instructions and advice should be followed!
Recommended personal protective equipment: protective gloves!
4.4
Procedures in the event of injury or other emergencies.
In the event of a work-related injury, stop working immediately, and if necessary, seek professional
medical assistance.
