Once the batteries have been inser-
ted, close the battery compartment
lid again and the radio remote control
is operational.
3.4 Teach-in process
This teach-in process is normally
carried out by the manufacturer and
you can skip this step.
If the status LED
and the keypad
s
illumination are flashing, the remote
control has not yet been taught in on
the dual drive.
In the following it is assumed that this is
the case. It will be described how the
teach-in process has to be carried
out.
If the status LED
and the keypad
s
illumination do not flash, but a
connection between double drive and
remote control is still not established
(bed cannot be adjusted), the double
drive and remote control must be
reset to the factory settings and re-
taught. Resetting to factory settings is
explained on page 11 of this manual.
10
Commissioning
3.3 Inserting the batteries
Insert the supplied batteries (2x 1,5V
AAA LR03) into the battery compart-
ment as shown in the picture. Ensure
that the batteries are inserted in the
right direction (+/-)!
