11
Comissioning
3.4
Teach-in process
This teach-in process is normally
carried out by the manufacturer and
you can skip this step.
If the status LED
s
and the keypad
illumination are flashing, the remote
control has not yet been taught in on
the dual drive.
In the following it is assumed that this is
the case. It will be described how the
teach-in process has to be carried
out.
•
Briefly press any button on the
remote control
►
The status LED
s
and the keypad
illumination flash alternately.
•
Press button
L
on the double
drive for approx. 1 s.
►
The back adjustment motor
moves briefly up/down.
•
The status LED
s
goes off, the
keypad illumination lights up
constantly. The teach-in process has
been completed successfully.
If the status LED
s
and the keypad
illumination do not flash, but a
connection between double drive and
remote control is still not established
(bed cannot be adjusted), the double
drive and remote control must be
reset to the factory settings and re-
taught. Resetting to factory settings is
explained on page 13 of this manual.
3.5
Initial position
Before you adjust the bed for the first
time, you should move the adjustment
drives to their starting position.
•
Press button
10
and keep it pressed.
•
The adjustment drives move to their
initial position and switch off then.
