![background image](http://html1.mh-extra.com/html/ls-industrial-systems/gimac-ii/gimac-ii_user-manual_1943846010.webp)
9
GIPAM User Manual
6 Operating
6-1 Measuring Part
6-1-1 Calibration Mode
A calibration mode of metering consists of 2 modes. One is adjusting offset and gain
of A/D converter and the other is selecting the ratings of analog
input signal. (Please do not adjust a calibration mode temporarily. If there are
necessity of adjustment, refer to appendix.)
6-1-2 Measurement display
The measurement result is displayed by pushing the measurement selection key.
Easurement key displays
1) Current
Display panel shows current value of phase
“
R
”
at the initial status.
Each phase of current measurement value will be displayed continuously
with the
“
A
”
unit by repeating to push the touch switch
“
A
”
. (It is possible
to check the type of wiring when operator pushes the Function and F
key at the same time.)
Type of wiring
Displayed phase
Remark
1P2W
1P3W
3P3W, 3P4W
Measurement value of each phase
R → N → T
R → S → T
FUNC + V
: PT Ratio
A
: CT Ratio
F
: Connection
W : Comm Address
Var : C/B Operatopn
Pf : Display All
Wh : C/B ON Time
Varh : Vo/Vomax
Summary of Contents for GIMAC-II
