XDesignerPlus Ver2.0 Communication Manual
5 / 13
Don't use overlapping IP address in unit network.
Item
Contents
Note
TCP/IP setting
High speed
link station number
0
Set station number when it communicated to high
speed between XGT PLC FEnet I/F module and
module.
Media
AUTO
Select media.
IP address
192.168.0.51
Set IP address of FEnet I/F module.
Required
setting
Subnet mask
255.255.255.0
Subnet mask
Gateway
192.168.0.1
Gateway address(Router address)
DNS server
0.0.0.1
Domain name server
DHCP
OFF (default)
If you use automatically assigned IP, check "ON".
Required
setting
Receive Wait time
15 (default)
Personal connection
unit
3 (default)
Maximum number of private service that can
connect simultaneously.
Driver(server) setting
Driver
XGT server
Required
setting
Host table setting
Unable
Host table
OFF
Module of registered IP address is only admitted
connection to FEnet I/F.(If it is unable, unregistered
Required
setting
(2) External device setup
Run "XG-PD Editor" program for communication setting and set as below.
If you want to change communication interface, modify refer to PLC manual.
1.
Run File > New File”. Select CPU Type and push OK button refer to “1. system configuration”.
2.
Connect CPU LOADER port of XGT Series and serial port of PC by serial cross cable.
(If there is USB port in CPU, connect USB.)
3.
Run [Online] > [Connection settings] menu. Select [Connection settings->Type] and click [Connect] button.
4.
Run [Online] > [I/O Information] and read slot number. Run [Online] > [Read Parameter] and read parameter information of slot
of communication card.
5.
Double click slot of FEnet card in [Project Window], show dialog box of [Default settings].
Set [Connection] and [Run Mode] as below and click [OK].
