Chapter 6 XG5000 Setting
6 - 11
The screen as below is after“Config. Upload (Dnet, Pnet)”. You can use Read / save area which
are blank.
[Figure 6.3.4] High-speed link block Setting
3) High-speed link block Setting
After uploading configuration data, input device information in the blank area.
Classification
Details
Master
Station No.
Display the Master station no. (0 ~ 123)
Station No. *1
Setting range for the slave : 1 ~ 123
Mode *1
Sending : Transmit the data from master module to slave module.
Receiving : Transmit the data from slave module to master module.
Read area
(Master module
→
Slave module)
XBM, XBC
Area to set the start address of device used for Sending.
Setting device : P, M, K, F, T, C, U, L, D, R, ZR
XEC
Area to set the start address of device used for Sending.
Setting device : A, M, I, Q, R, W, F, K, L, U
Save area
(Slave module
→
Master module)
XBM, XBC
Area to set the start address of device used for Receiving.
Setting device : P, M, K, F, T, C, U, L, D, R, ZR
XEC
Area to set the start address of device used for Receiving.
Setting device : A, M, I, Q, R, W, F, K, L, U
Send data
Receive data
(Byte)
Display input/output points of slave module by the bytes.
- In case of I/O module of 8 bits or less, please set 1 byte.
*1 : Area is not able to set
[Table 6.3.2] High-speed link block Setting
Summary of Contents for XBL-PMEC
Page 50: ...Chapter 5 PROFICON Setting 5 18 Figure 5 4 8 Network topology collected and composed...
Page 84: ...Chapter 7 Program Example 7 12 Figure 7 3 3 Screen of communication module setting...
Page 91: ...Chapter 8 Troubleshooting 8 3 8 5 Troubleshooting 8 5 1 Connection error on PROFICON XG5000...
Page 99: ...Appendix A 7 A 4 External Dimensions Unit mm XBL PMEC XBL PMEC...