(6) Parking
Stop the tractor on a level surface, not on a slope.
Disengage PTO and place all the transmission
shift lever in NEUTRAL position and apply the
parking brake.
Stop engine and remove ignition key.
Before you leave the operator’s station, wait for
engine and all moving parts to stop.
▶
If it is necessary to park the tractor on a slope, furthermore with loaded trailer, the
tractor may roll down, even though the parking brake is applied. In this case, apply
the gear in low speed and apply the chocks or blocks to all the tire.
Caution
the gear in low speed and apply the chocks or blocks to all the tire.
- Mechanical : downward slope
⇒
reverse 1 gear / upward slope
⇒
forward 1 gear.
- HST Type : place the range gear shift lever to the lowest speed.
Caution
Turbocharger
(7) Handling the Turbocharger
(if fitted)
Before accelerating or starting the tractor fitted
with the turbocharger, allow the engine to idle at
1000 rpm for about 30 seconds to ensure that
the turbocharger is correctly lubricated.
Before stopping engine fitted with the
turbocharger, allow the engine to idle at 1000
rpm for at least 5 minutes. This allows the
turbocharger and manifold to cool, preventing
deformation of the components.
4
4
4
4
- 10
deformation of the components.
After stopping engine fitted with the turbocharger,
cover the exhaust tail pipe to prevent the
turbocharger rotating in the wind, resulting in
possible damage to the bearings. The
turbocharger turbine must be prevented from
rotating freely with the engine off, as the shaft
bearings will not be lubricated.
