![background image](http://html1.mh-extra.com/html/ls-tractor/xg3025/xg3025_operators-manual_1943872114.webp)
5 - 20
(3) Tension adjustment of Engine belt
z
If the tension of fan belt exceeds the standard
value, loosen the bolt and adjust the tension.
- Belt tension : crank shaft pulley ~ alternator
pulley
- Normal : approx. 10~12mm (0.4~0.5 in)
(if pressed by 98N (22 lb.f))
z
When adjusting belt tension,
1.
Loosen two bolts
of alternator and the hinge bolt
of the adjusting plate. insert the bar between
crank case and pull the bar to apply tension to
the belt.
2. With proper tension, tighten the bolts attached to
the adjusting plate of alternator.
3.
If the belt tension becomes normal, tighten the
other bolts and check the tightening torque.
(4) Toe-in
z
Check and adjust Toe-in of the front wheel as
follow.
Normal value ; B – A = 0~5 mm (0~0.2 in.)
z
Unscrew the lock nuts of the tie rod.
z
If you turn the tie rod clockwise at right hand side
“B-A” shall be increased.
z
After checking that Toe-in is correct, tighten the
lock nuts.
A
Lock nut
Lock nut
B
FRONT
Tie rod
Adjusting plate
Bolt
Cooling water
pump pulley
Crank shaft
pulley
Alternator
Pulley