![background image](http://html1.mh-extra.com/html/ls-tractor/xg3025/xg3025_operators-manual_1943872127.webp)
5 - 33
ⓑ
Removing Jumper cables
z
Remove jumper cables as referring to the right
figure.
▶
Pay attention not to change the (+) and (-) pole. If not, it may cause a failure of
electric circuit or the damage of wire and even the polarity of battery can be
changed at over-discharged state.
Notice
< Removing order of jumper cables >
①
②
③
④
Engine
Normal
Discharge
Red cable
Black cable
Caution
▶
The gas generated from the battery can be exploded by spark.
▶
The negative(-) cable of auxiliary battery must be connected to the engine block,
not to the tractor battery.
▶
Keep all flames and sparks away and DO NOT smoke
while charging the battery.
④
How to use jumper cables
※
If the battery
which is attached to the tractor is discharged and needs to connect a auxiliary battery,
follow the instructions as below.
< Connecting order of jumper cables >
①
②
③
④
Engine
Normal
Discharge
Red cable
Black cable
ⓐ
Connecting Jumper cables
z
Check the followings before connecting the
cables.
- Is the spring
of clamp normal?
- Is the cable and clamp cut-off?
1. Stop engine, apply parking brake and remove
the ignition key.
2. Connect two (+) terminals of both
batteries with
red cable. (tractor battery-
①
, auxiliary battery-
②
)
3. Connect one end of black cable to (-)
terminal(
③
) of auxiliary battery and the other
end to engine block desired to start (
④
).
4. If engine does not
start, check
the electrolyte
level of each battery.