②
②
②
②
Engine oil filter replacement
▶
If you drain the engine oil while
the engine is still warm, the
impurities shall be drained
completely.
Notice
(1) Replacing Engine oil and Filter
①
①
①
①
Engine oil drain
When the engine stops and the oil has cooled
down, loosen the drain plug of oil pan to drain
the oil completely.
5-8. Every 300 hour check
Oil injection inlet
Drain plug
U5010/U5020
Disassemble the oil filter using the filter wrench.
Remove any dirt to the oil filter or crank case by
blowing with compressed air.
When assembling the new oil filter, check if the
rubber packing is fixed in the groove completely.
Apply the engine oil to the packing.
When assembling the oil filter to the bracket,
attach it so that it can be turned by ¾~1
revolution after the packing and filter case are
contacted.
③
③
③
③
Engine oil injection
Attach the drain plug and tighten the normal
torque. (normal torque :4.0Kg.m(28.93ft.lbs))
Inject the oil into oil injection inlet by normal
capacity.
Oil injection inlet
Drain plug
U5030
5
5
5
5
- 15
capacity.
Engine oil capacity
:
7.0 ℓ(1.8gal)– U5010/U5020
9.0 ℓ(2.4gal)– U5030
After starting the engine, check if there is oil
leakage through idle operation for several
minutes. If finding oil leakage, tighten the filter
once again.
After stopping the engine, check the oil level
again after about 30 minutes.
If the oil level is between high limit and low limit
of oil level gauge, it is ‘NORMAL’.
If the metal is attached to the element of oil filter
to be disassembled, contact your authorized
dealer.
Close
Open
Packing