5 - 23
5-9. Every 500 hour check
Drain plug
Oil check port
Oil filling inlet
(1) Changing Front axle oil
z
Stop tractor on a level surface and apply
parking brake.
z
Remove left/center/right drain plugs and oil
filling inlet to drain oil completely.
z
Wrap the sealing tape on the plugs and tighten
the drain plugs to original position.
z
Add new oil into the oil filling inlet.
z
After about 5 minutes later, Unscrew the oil
check port plug, and check if the oil flows out.
z
Tighten the oil filling inlet plug.
Oil capacity : 8 L (2.1 U.S.gals.)
(2) Changing Transmission oil
z
Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm oil
and lower implements and stop the engine.
z
Set container under drain plugs and remove the
drain plugs under the transmission and drain oil
completely.
z
Clean metal sludge stuck to drain plugs and
tighten the drain plugs again with copper washer.
z
Add new oil until the oil level is between MIN and
MAX mark of the oil gauge.
Oil capacity : 43 L (11.4 U.S.gals.)
▶
The contaminated oil may reduce the durability of transmission and cause the
failure of hydraulic system. Clean around oil filling inlet and then pull the oil gauge.
Caution
Drain plug
Copper washer
<Oil gauge >
Max.
Min.
Oil filling inlet,
Oil gauge
