28
ACE M2
11. TROUBLE SHOOTING GUIDE
CODE
SOLUTION
E01
Reason
: signal failure within the connection between computer and controller
Solution
:
A.
Check that the wires connecting the
computer and controller
are not
damaged and
are connected well.
B. Replace the IC of controller or computer
.
E02
Reason
: Burst Clash
Solution
:
A. Check the power is right, if not, use correct power to test.
B. Check if the bottom control was burnt out, change a good one and
reconnect the motor wire.
E03
Reason
: Speed feedback is not detected by controller when motor is running
Solution
:
A. Check if the motor rotates when the machine starts before displaying
E03. If so, conduct the following checks.
1. Check that the speed sensor is attached well.
2. Check that the speed sensor wires are not damaged
3. Check that the interface between light sensor and 4 white pin on
the controller is connected well
4. Check if the peripheral area of the four white pin is damaged
5. Consider replacing controller and IC
B. If the motor does not running when you start the machine and E03
shows, check if the motor is stuck. If the problem persists, consider
replacing the motor.
E05
Reason
: The voltage is over the protection value when the motor is running.
Solution
:
A. Check if the motor is in good condition, and if there anything stuck in
running belt or roller so as to unnaturally increase the resistance of for
the motor.
B. Replace the controller
E06
Reason
: Treadmill not starting after pressing the Start button.
Solution
:
A. Check the magnetic parts of the safety key are in contact with the
treadmill
