LSG Dyna, User Manual

24

No. 

Description                 Specs   

    Qty

83

Bolt 

              ST4.2*9.5 

      4

84

Bottle Cage   

       1

85

Bottle Cage   

       1

86

Bolt 

              4.2*9   

      8

No. 

Description                 Specs   

    Qty

87

Bolt 

              ST4.2*12 

      8

88

Bolt 

              M8*12   

      2

89

Bolt 

              M6*65  

      2

XII. TROUBLE SHOOTING GUIDE

Code   

Reason                  

  Solution

E01

Message wire is broken or not 
connected well

1.  Check if the computer and bottom
    control board wire connect well.
2. Check if IC on bottom control board
    is loosen, reset the IC.

|  TROUBLE SHOOTING GUIDE

E02

Burst clash

1.  Check if the power voltage is 50%
    lower than the normal voltage,
    please use the normal voltage to
    test.
2. Check if the control board is burnt
    with irregular smell, replace a
    control board. 
3. Check if the motor wire is well
    connected, reconnect it.

E03

No sensor signal

1.  Check if the signal light on control
    board is light on, if the signal light
    is burnt out, change a signal light. 
2. Check if the plug of sensor is well
    connected.
3. Check if the magnetic sensor is
    broken or well connected, reconnect
    it or replace a magnetic sensor.

E05

Current overload protecting

1.  Overrated loaded or the motor
    is stuck, cause excessive current,
    machine will start self-protecting
    system. Adjust the machine and
    restart.
2. Check if the motor has noise from
    motor or if the motor / bottom
    control board were burnt out, if
    burnt out, change motor and
    bottom control.
3. Check if the power voltage is wrong,
    use right voltage to test again.