14
4.3. INNER INSTALL PROGRAM:
Press ‘PROG’ button to choose the preset program from P1----P15. When the program is selected the time
window will show default data and blink. Press
SPEED+/- or /-
button to set the running time. Each
program has been divided into 16 section. Each exercise time = the setting time/16.
Press ‘START’, the machine will run at the first section speed and incline data. When the section is over, it
will move to next section automatically. The speed and incline will change according to the program setting.
When program is finished the machine will slow down to a stop.
You can still change the speed and incline by the
SPEED+/-
and
/- or Left/right Handrail Button
.
When the program enters the next section the Speed/Incline will come back to the default setting. You can
stop the program by pressing “Stop” or pulling the emergency safety key.
At the end of the program mode the treadmill will flash with 15 beeps, after which all data will be cleared to 0
and come into standby status.
5. PULSE TEST
When holding the hand pulse sensor by two hands the reading will show after 5 seconds. In order to get
proper reading, hold it for more than 30 seconds. The pulse data is just for reference and is not a medical
device or medical data.
6. BODY FAT TEST
When the treadmill is on standby, press ‘PROGRAM’ button until it shows ‘FAT’ show in the window. ‘FAT’ is
body fat test mode.
Press ‘MODE’ to choose parameter ‘SEX / AGE / HEIGHT / WEIGHT’. The corresponding window will show
“-1-”, “-2-”, “-3-”, “-4-". Press SPEED+/- to adjust the data and set the parameter. The corresponding window
will show the data.
Press ‘MODE’ button to finish, the window will show “-5-” and “---” enter ready to go condition. Hold the
handle pulse with two hands, it will show your BMI data after 5 seconds.
6.1 Data display and set range
Parameter Type
default
Setting range
mark
SEX (-1-)
0 (MALE)
0—1
0= MALE 1= FEMALE
AGE (-2-)
25
10—99
Summary of Contents for VULCAN M2
Page 32: ...32 10 EXPLODED DIAGRAM...
