27
4. How to check the running mat for proper lubrication:
1. Disconnect the main power supply.
2. Fold the treadmill up into the storage position.
3. Feel the underside surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend that you use a silicon-based spray to lubricate your Lifespan treadmill. This can be
purchased from us or any hardware store.
5. Adjusting the Running Belt
A
B
C
Place treadmill on a level surface. Run treadmill at
approximately 4km/h, checking the running condition.
If the belt has drifted to the
right
:
Whilst the treadmill is running at 4km/h, carefully turn
the
right
adjusting bolt 1/4 turn
clockwise
. Then
monitor treadmill until the belt centers. Repeat until the
belt correctly centers. See
Picture A
If you have over adjusted the belt and it drifts to the
right, carefully turn the
right
adjusting bolt
anticlockwise
until the belt centers.
If the belt has drifted to the
left
:
Whilst the treadmill is running at 4km/h, carefully turn
the
left
adjusting bolt 1/4 turn
clockwise
. Then
monitor treadmill until the belt centers. Repeat until the
belt correctly centers. See
Picture B
If you have over adjusted it, carefully turn the
left
adjusting bolt
anticlockwise
and until the belt centers.
To adjust the
tightness
of the belt:
Turn the treadmill off. Turn both the left and right
adjusting bolts 1/4 turn clockwise. Repeat until the belt
correctly tightens.
See
Picture C
If the belt is over tightened, simply do the opposite to
loosen.
Summary of Contents for VULCAN M2
Page 32: ...32 10 EXPLODED DIAGRAM...
