Sphensor
–
User manual
LSI LASTEM SRL
INSTUM_04291
Pag. 21 / 32
4.3.3
Hung
If you need to have the sensor hanging, it must be installed with the appropriate component MK5351. The
attachment to the ball is the same as that of the stem. Remove from these the M3 nut and place it in the
special quarry, then tighten the component with the M3x10 screw supplied.
4.3.4
Via stainless steel base
Using the stainless steel base is the most convenient solution if you want to place the sensor on a surface, a
desk or a table. The weight of the component allows unlimited tilt of the sensor without compromising its
stability. The rubber ring below prevents sliding on particularly smooth surfaces and protects any glass sur-
faces or other delicate surfaces.
4.3.5
Via easel
As an alternative to the previous systems, one can consider the installation on tripods or mini-tripods on the
market. This choice involves the replacement of the stem supplied with a specially designed one (supplied
on request) which presents on the inside a hexagonal nut with thread W 1/4'', instead of the M4 stud. This
thread allows positioning also on various photographic media on the market (tripods, pliers, articulated arms,
etc.)
