LSI LASTEM M-Log – User’s manual
55
5.7
Operating of low energetic consumption
There isn’t a very configuration for low energetic consumption mode.
Anyway in order to optimize energy consumption, proceed as follows:
Use the highest possible value to program the acquisition rate of the measures, according to
the dynamic feature of the quantity's signal to be sampled (see §
Errore. L'origine
riferimento non è stata trovata.
);
Keep the actuation time to energize the sensors low without compromising the reliability of
the measure (see §
Errore. L'origine riferimento non è stata trovata.
);
Use the lowest possible acquisition time required to, however, have the sensor send the
measured signal in a correct manner (see §
Errore. L'origine riferimento non è stata
trovata.
);
Use a high rate, and only if necessary, to program the rate for probe control (see §5.2.6);
Switch the display off manually or program it to automatically shut off by itself (see §4.3.5);
the display can be turned off by pressing of
button, while displaying the mask of
measures;
Disable the fast acquisition mode of the measures which was possibly enabled while the
instrument was switched on (see §5.2.5).
Cancel not-used actuation logics (see §
Errore. L'origine riferimento non è stata
trovata.
);
Manage modem switch on through actuator 3 (programmed with timed logic), or
programming GPRS communication through modem activation;
In case of sensors or telephone modems fed continuously, don’t use instrument’s batteries,
but use other ones (if possible). In this way the instrument can operate even if modem and/or
sensors aren’t fed, and so they aren’t operating;
ATTENTION
: Default configuration programmed on instrument is not the one of lowest energetic
consumption.
