Chapter 7 Diagnosis Function
7-14
[Figure 7.4.4] XG5000 remote stage 1 connection
(c) Network type
Select a network type for stage 1 connection among Rnet, Cnet, FEnet, RAPIEnet and EtherNet/IP. EtherNet/IP is to
be selected because stage 1 connection is applied through EtherNet/IP in [Figure 7.4.4].
(d) Base No.
Specify the base No. where EtherNet/IP module of PLC #1 for remote connection is installed.
Since XGB does not
have a base, enter 0 as the base number.
(e) Slot
It indicates the slot number where EtherNet/IP module is installed in locally connected PLC via RS-232C. Select No.1
in [Figure 7.4.4] since EtherNet/IP module installed on PLC #1 is on slot No.1.
(f) IP address
Specify the IP address of EtherNet/IP module installed in the PLC which will be connected with XG5000 in the
network 1. Use the IP address of EtherNet/IP module installed in PLC #2 station, 192.168.91.189
in [Figure 7.4.4].
Summary of Contents for XBL-EIPT
Page 53: ...Chapter 5 Installation of Software and communication Parameters 5 18 ...
Page 98: ...Chapter 7 Diagnosis Function 7 11 Figure 7 3 4 FlashArea Log Screen of System Log ...
Page 106: ...Chapter 7 Diagnosis Function 7 19 Fig 7 4 9 Remote 2 connection directly via Ethernet ...
Page 119: ...Appendix A 12 A 3 External Dimension Dimension Unit mm XBL EIPT ...