SP640_
________________________________________________________________________________
8| Operating Manual ver. SP640-EN-1.1
INSTALLATION AND WIRING
SP640 speaker can be mounted to the wall, on a pole or suspended through
the suspension points.
For installation on a pole, use the pole mount plate in the bottom of the case,
speaker can be mounted on a tripod or on another speaker (sub).
For suspended installation, there are six brackets inside the case: three in
the top, three in the bottom. Each bracket is secured to two adjacent internal
side of speaker using two M10 screwbolts.
If needed, replace the screwbolts with eyebolts.
More detaliled:
One bracket is connected between top and left side of case.
One bracket is connected between top and right side of case.
One bracket is connected between top and rear side of case.
One bracket is connected between bottom and left side of case.
One bracket is connected between bottom and right side of case.
One bracket is connected between bottom and rear side of case.
When installation is in suspended mode, use the upper or lower brackets.
Unscrew one of the two screws hold a single bracket, the second screw
must be screwed only after the first one has been tightened to avoid the
bracket moves.
Use plugs suitable to support the weight of the entire apparatus.
