3
4
6. System Diagram:
Unlimited receivers can be installed within effective distance, no wiring needed between the receivers,
which can be less or more in quantity according to your need for the installation, if you want to increase
or decrease the receivers, just activate or cancel the control ID on the remote control will be fine, no any
changes and effects on the other receivers.
No quantity limited of the receivers.
On
/
Off
Touch
Color
Circle
Speed+/Speed-
CT+/CT-
(Press 3 seconds saved
)
CT Shortcut Keys
BRT+/BRT-
Sync Status Indicator Light
Delay
Off Keys
BRT Shortcut Keys
(Keep pressing to adjust
brightness continuously)
Scene-save Keys
★
press “DELAY OFF KEY” in 3 seconds, the buzzer can be on or off.
5. Other Special Functions
:
Turn on the remote, long press the on/off key for 5 seconds until the red light flashes 3 times, and then the
green light flashes, the numbers of the green flash will be the frequency point of the remote. you can only edit the
frequency point after 3 seconds.
Method 2: long press “on/off” key over 5 seconds, the green light flashes, the flash times plus 1 means the
frequency point accumulate 1. In short, long press the “on/off” key 5 seconds each time, the frequency
point will accumulate 1, which will again become value 1 when added to 12, and that cycle repeats.
A. Reset Function
:
B. Check and Edit the Frequency Point on the Remote:
Long
press
simultaneously
,
release
the 2
keys
after
3
seconds
,
the
remote
will
auto
off
,
means
reset
completed
.
and then
could
restart the remote.
Feature:
Reset function is available when remote operates abnormally.
Operation:
a.
Multiple remotes sync-control becomes available when they use the same frequency point.
Revising the frequency point to eliminate the external disturbance. 12 revisable frequency points for user.
b.
After reset or revised the frequency points in the remote, receivers only can be used after relearn the ID.
Attn:
Feature:
Check the Frequency Point on the Remote:
Edit the Frequency Point on the Remote:
In frequency changing state
Method 1: short press any key from 1-9, the frequency point will be 1-9 correspondingly, the green light will flash in
the same numbers. Press again any key or touch the color circle to exit the frequency edit state.
Frequency
Rate
T2
2
.
4G LED Color Temperature Controller Manual
T2
2
.
4G LED Color Temperature Controller Manual
