ABOUT YOUR HOVERBOARD
CHARGING INFORMATION
Your hoverboard includes a lithium battery, but the battery does not come fully charged. Before your first use and as needed, charge
the battery according to the instructions below and the safety information on pages 2 and 3. Always charge the battery inside the
unit in a clean, dry location away from direct sunlight, flames or sparks.
Plug the charger into a wall outlet. The light on the charger will be green.
If the green LED does not turn on, try a different outlet.
Ensure the hoverboard is turned OFF. Then, plug the charging cable into the port on the unit. The charging LED
on the charger should turn red while charging. The light will turn green again when it is fully charged. Charge
time is approximately 2 hours.
Unplug the charging cable from the unit and the wall outlet.
Turn the hoverboard ON when you are ready to ride.
9
4
•
An ADULT must charge the unit each time, as the charger is not a toy.
•
Only use the included charging cable or risk voiding the limited warranty.
•
Always turn the unit OFF after use to conserve battery power and maintain battery capabilities.
•
Always recharge the battery after each ride and before storing. Do not overcharge.
•
Ensure the charging port is completely dry before charging.
•
Allow the battery to cool down before recharging.
•
Keep the battery and hoverboard at room temperature when not in use. Do not use, charge or store in
excessive heat, humidity or cold.
•
Unplug the charging cable from the power outlet when not in use.
•
Length of usage and range may vary due to riding conditions, weather, user weight and maintenance.
•
Constant stopping and riding may affect the ride time.
Tips
Green Bars = Charged
Three Yellow Bars = Charge Unit Buzzer & Warning Light
CHARGE IMMEDIATELY
50-100% Battery Power
10-50% Battery Power
0-10% Battery Power
1
2
3
4
Power
Charging
Port
• When the battery is overextended for a long period of time (such as climbing a steep slope), the unit will alarm.
Rider should turn around. The unit will shut down after 15 seconds.
•
When the battery voltage is too low, the hoverboard will issue a buzzer alarm.
•
When the battery voltage is lower than the protection mode, the system will automatically shut down
after 20 seconds.
When the battery is running low or depleted, DO NOT continue driving the unit. The unit will not
operate properly when the battery is too low. Continuing to ride the unit may cause injury or damage to
the unit and will negatively affect the battery life.
The LED lights on the sides of the
unit are steering lights. While the
unit is ON but not moving, the lights
will pulse. While you are moving, the
lights will be lit in the direction you
are turning (left or right).
NOTE
LED Lights
Charging Port
Power Button
LED Digital Display
Front Platform
(Steering)
Specification Information
L x W x H
(833 x 210 x 228 mm)
32.8 x 8.3 x 9 in.
5.5 in. (140 mm)
24V
350 rpm
400 W
LG Lithium
4.3Ah
29.4 V
100-240 V/AC
≥
4N. m
BLDC
Motor
Rated Voltage
No Load Speed
Rated Output
Rated Output Torque
Battery Type
Battery Capacity
Nominal Battery Voltage
Charger Input
Charger Output
Charging Time
Max Speed
Range
Turning Radius
Grade Ability
Wheel Base
Net Weight
27.7 lbs. (12.6 kg)
Max. Load
220 lbs. (100 kg)
Min. Load
55 lbs. (25 kg)
3 in. (78 mm)
8 in. (203 mm)
iPX4
32°-104°F (0°-40°C)
32°-104°F (0°-40°C)
32°-104°F (0°-40°C)
Min. Ground Clearance
Tire
IP Rating
Operating Temp.
Charging Temp.
Charger Model
Battery Working Temp.
29.4V /2A
2-4 Hours
7 mph (12 km/h)
6.2 mi. (10 km)
0m
≤
8°
FY0632942000
Charger Manufacturer
Shenzhen Fuyuandian
Power Co., Ltd
