- SEAT PEOPLE ON THE CHAIR WHEN THE MASSAGE IS STOPPED.
- DO NOT EXCEED THE MAXIMUM ALLOWABLE LOAD.
- PLUG THE WASH UNIT INTO AN EASILY ACCESSIBLE SOCKET, CHECKING
THAT THE NETWORK POWER SUPPLY ( V ) COMPLIES WITH THE WASH UNIT
REQUIREMENTS.
- AVOID THE USE OF EXTENSION CABLES; WHEN POSSIBLE, PUT THE PLUG
DIRECTLY INTO THE SOCKET.
- KEEP THE POWER SUPPLY CABLE AWAY FROM PASSAGEWAYS SO TO
AVOID CRUSHING AND NOT TO HINDER PASSAGE.
- TO AVOID DANGEROUS ELECTRICAL SHOCKS, USE A SOCKET PROPERLY
CONNECTED TO THE POWER SUPPLY NETWORK. WE ADVISE YOU ASK FOR
YOUR INSTALLER’S SUPPORT.
- WHEN THE WASH UNIT IS NOT IN USE, REMOVE THE PLUG FROM THE SOCKET.
- AT THE END OF THE WASH UNIT LIFE CYCLE, CUT ITS POWER SUPPLY CABLE
WITH A PAIR OF SCISSORS AFTER REMOVING THE PLUG FROM THE
SOCKET, AND FOLLOW THE INSTRUCTIONS FOR A PROPER DISPOSAL.
6 . 2 w o r k i n g p o s i t i o n
Operators are instructed to stand behind the wash unit as shown in Figure 2, so that
their hands can move freely above the basin, where the client’s head is resting for
washing.
Warning
fig. 2 working position
22
User manual
USER MANUAL
EN
USER MANUAL
23
User manual
6 . 3 i n s t r u c t i o n s f o r a c o r r e c t O P E R A T I O N
The correct sequence the operator must execute is as follows.
1_ Check that the shampoo unit is correctly positioned on a flat lavelled surface
and that it is not wet or has signs of damage.
2_ Check that the working environment is suitable with correct lighting
and correct ventilation.
3_ Check that the shampoo unit is correctly connected to the hydraulic circuit
so that warm and cold water are available and it is possible to mix
them to obtain the right temperature.
4_ Check that the water used to wash hair is correctly drained (check that the
drainpipe is not clogged).
5_ Check that the power supply cable and the plug are not damaged.
6_ Check that the socket’s power supply is 100/220-240 V ~ 50-60 Hz.
In case of anomalies during these checks, the operator should inform
the person in charge.
7_ Put the plug in the socket.
8_ Seat the client on the chair.
9 _ If requested, use the appropriate push-button panel to start and stop the massage
movement, as shown in figure 3.
NB. Each button has to be held down to for 1 second
IN ORDER TO AVOID
UNWANTED ACTIONS.
The massage cycle lasts 3 minutes. To stop the massage use the stop-button, as
shown in figure 3.
AFTER 3 MINUTES IT WILL STOP INDEPENDENTLY.
EN
