Airfusion Atlanta Installation Instructions
11 | P a g e
V1.0-EU (11/2019)
ATLANTA
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the “
” button of
transmitter 2 for 10 seconds within 30 seconds of switching the power
ON to the receiver of ceiling fan 2.
There will be a notification ‘beep’ sound
from the receiver to indicate that the paring process is
successful.
Turn ON and change the speed of ceiling fan 2 by the transmitter to check the operation and successful
pairing.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC
ceiling fan remote and receiver.
Issues:
Loss of control - Fan is only running at high speed after installation
Loss of control - No reverse function after installation
Loss of control - Remote cannot communicate with the receiver
Solution:
Switch off the main power of ceiling fan.
Switch on the main power of the ceiling fan.
Follow the same process as described in the ‘Paring remote
and receiver’ section to repair your fan.
Turn on and select the different speed of the ceiling fan to check the operation of the fan.
AFTER INSTALLATION
NOTE: Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet.
If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few
centimeters is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down
rod are secure.
