Nordic Installation Instructions
9 |
P a g e
Transmitter / Receiver paring for Ceiling fan 2:
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
Install the 3V DC battery in the compartment. Please make sure the polarity of the battery is correct. Fig.10
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own isolation
switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the
“
” button of
transmitter 2
for 3-5 seconds within 60 seconds of switching the power ON to
the receiver of ceiling fan 2.
The fan will move slightly and stop to indicate the paring process is activated.
If the fan has light kit attached, the light will flash on and off to indicate the paring process is activated.
Turn ON and change the speed of ceiling fan 2 by the transmitter to check the operation and successful pairing.
Note: The pairing of the transmitter and receiver is required if only one ceiling fan is installed.
When more than two ceiling fans are installed near each other, please refer to the instruction
above.
Remote Control Buttons
1
- FAN SPEED CONTROL BUTTON:
There are 6 available speeds.
“
I
” button is for the lowest speed, and “
VI
” button is
for the fastest speed.
NOTE:
when you turn on the fan for the first time or switch the main power to the
controller, you need to start the fan on hight
“
VI
” speed first and then choose a
lower speed. A 5-10 seconds is required to allow the DC fan to respond to the
remote each speed or fan direction seletions.
2
- FAN OFF BUTTON:
Press the button to turn the fan off.
3
- REVERSE FUNCTION BUTTON:
Press the button to activate the reverse running function. The fan must be
operating to activate the reverse function.
4
- LIGHT CONTROL BUTTON:
Press the button to turn the light ON/OFF.
Fig. 13
Fig. 11
Fig. 12
