Remote Port Security Device
User’s Guide
555-024-402
Issue 1
October 1996
RPSD System Administration
Page 3-7
Command Functions
3
Description
Use the Add User command to add an RPSD Key user or an administrative user
to the list of users on the Lock. A total of 60 RPSD/Key (non-administrative) users
and administrative users are allowed on each Lock. Of the 60 users, 10 are
permanent users reserved for Lucent Technologies personnel and cannot be
removed. The following are the 10 permanent Lucent Technologies RPSD user
IDs:
■
User IDs reserved for Lucent Technologies personnel using the INADS
system
— ATT-INADS1
— ATT-INADS2
— ATT-INADS3
— ATT-INADS4
■
User IDs reserved for Key users and engineers at the Technical Services
Center in Englewood, Colorado (all products):
— ATT-TSC001
— ATT-TSC002
■
User ID reserved for Lucent Technologies personnel at the Tier 3 location
at the Denver Works Factory:
— ATT-PECC01
■
User ID reserved for Bell Laboratories field support for System 85 and
DEFINITY
®
Enterprise Communications Server (ECS), Generic 2
— ATT-LABS01
■
User ID reserved for Bell Laboratories field support for System 75 and
DEFINITY ECS Generic 1
— ATT-LABS02
■
User ID reserved for Bell Laboratories field support for AUDIX
— ATT-LABS03
In addition to normal access capabilities, administrative users can gain access
to the RPSD Lock to change Lock parameters. If the AUX Security feature is
enabled, the administrative user must use a password or a passkey device
associated with the user ID to authenticate his or her administrative access
capability. See “Passkey Authentication” in Chapter 4 for instructions for the
passkey authentication process.
When the administrative user is added with a password requirement (a
w
entered
in the
<authentication_mode>
parameter), the assigned password is entered at
the “Enter Password” prompt and then entered again at the “Verify Password”
prompt. This ensures that the intended password is typed correctly. The unique