Remote Port Security Device
User’s Guide
555-024-402
Issue 1
October 1996
Page ix
When installing telephone equipment, always follow basic safety precautions to reduce
the risk of fire, electrical shock, and injury to persons, including:
■
Read and understand all instructions.
■
Follow all warnings and instructions marked on or packed with the
product.
■
Never install this unit or telephone wiring for it during a lightning storm.
■
Never install a telephone jack in a wet location unless the jack is
specifically designed for wet locations.
■
Never touch uninsulated telephone wires or terminals unless the
telephone wiring has been disconnected at the network interface.
■
Use caution when installing or modifying telephone lines.
■
Use only Lucent Technologies-manufactured circuit packs, carrier
assemblies, and power units in the control unit.
■
Use only Lucent Technologies-recommended/approved accessories.
■
Do not install this product near water, for example, in a wet basement
location.
■
Do not overload wall outlets, as this can result in the risk of fire or
electrical shock.
■
Do not attach the power supply cord to building surfaces. Do not allow
anything to rest on the power cord. Do not locate this product where the
cord will be abused by persons walking on it.
■
Unplug the product from the wall outlet before cleaning. Use a damp cloth
for cleaning. Do not use cleaners or aerosol cleaners.
■
Do not operate the system if chemical gas leakage is suspected in the
area. Use telephones located in some other safe area to report the trouble.
!
WARNING:
DO NOT open the RPSD Lock or Key devices. There are no user
serviceable parts inside the units. Only an authorized technician should
open a unit for required maintenance or upgrading purposes.
SAVE THESE INSTRUCTIONS
The exclamation point in an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the product.
