Procedure 6.12: SCHEDULE AUTOMATIC ODD BACKUP
OVERVIEW
This procedure requests to schedule the ODD backup to run periodically at specific intervals.
NOTE:
During heavy recent change activity, an ODD backup has a slight chance of aborting because of a lack of
resources for the backup to execute. Requesting ODD backup during heavy recent change activity is not
recommended because this will affect the ODD backup and recent change performance and response
time. If a backup aborts, re-request the ODD backup during a period of light recent change activity. Failure
of ODD backup will cause a minor alarm.
PROCEDURE
1.
At master control center (MCC), type and enter:
BKUP:ODD[,FULL][,AM][,CMP=0][,NRODD=a&&b][,RODD=a],EVERY=c,AT=d;
Where:
FULL
= Back up the entire ODD unconditionally. If FULL is not specified, only those ODD
blocks that have been altered since the last ODD backup will be backed up (a differential
backup). The AM ODD backup is always a full backup (that is, a differential backup of the
AM ODD in not available).
CMP
= Back up the CMP ODD.
CMP
= Back up the CMP ODD.
NRODD
= Back up the SM nonredundant ODD.
RODD
= Back up the redundant ODD. (The default is the entire system [the AM, the CMP,
NRODDs of all SMs and RODD] if none is specified).
a
= SM number or the lower limit of a range of SM numbers.
b
= Upper limit of a range of SM numbers.
c
= Interval in days (0-90) between successive ODD backup runs.
d
= Time of day in in hours and minutes when ODD is to be backed up.
Response:
NG
= No good. Valid values are as follows:
INVALID CMP RANGE = the input request is not valid.
INVALID SM RANGE = the input request is not valid.
PF
= Printout follows: Request accepted and the corresponding
BKUP:ODD
output message
will follow:
RL
= Retry later. The request cannot be executed now due to unavailable system resources.
Results:
Automatic ODD backup scheduled.
2.
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
235-105-210
October 1999
Copyright © 1999
Page 1
Summary of Contents for 5ESS-2000
