Cannot assign pattern to DFI Y due to lack of available timeslots
- Unassign one DFI-H2 using RC/V,
then continue with the conversion. The unassigned DFI-H2s can be added after reengineering the DI TS
usage. The previously mentioned DFI-H2s can also be connected to the other DI (if possible).
If the recent change failed due to system resources error, repeat the recent change input again and, if that
fails again, exit the recent change completely to allow AUDIT to clean up and enter recent change to repeat
the transaction again. If for some reason, a recent change view 22.9 update repeatedly fails, unconditionally
restore all OOS DFI-Hs back to service (to bring the RISLU back to the preconversion status) then contact
the appropriate Lucent Technologies Customer Support organization.
If after the SM full initialization and all RISLU circuits (DFI-RH, CC CD) are OOS and cannot be restored
individually, or calls cannot be completed, seek technical assistance.
11.6.8 Verify RISLU Configuration and DFI Mode
1.
At the RC/V Terminal in RECENT CHANGE mode, go to the RISLU Common Equipment view (22.9),
selecting the REVIEW operation.
2.
Verify the CONFIG attribute is set to RACTSTBY.
3.
Verify DFI MODE attribute as ZCS or B8ZS.
4.
Correct any errors using RC/V terminal in the update mode.
5.
Exit the RISLU Common Equipment view.
11.6.9 Initialize the SM
1.
Various software relations and attributes plus dynamic data required to initialize the ERISLU must be updated
prior to restoring the ERISLU. This is done by executing a full initialization without pump on the SM in
question.
CAUTION:
A full initialization without pump will cause a service interruption to all customers being served by
the SM.
At the MCC, execute a full initialization without pump by entering the following message:
CMD:
INIT:SM=x,FI;
Where:
x = SM number
The converted ERISLU will automatically be restored to service at the completion of the SM full initialization.
11.6.10 Diagnose the DFI-Hs and ERISLU
11.6.10.1 Diagnose the DFI-Hs
1.
At the completion of the SM full initialization, diagnose all equipped DFI-Hs and the ERISLU's CCs and CDs
(one at a time).
NOTE:
The restore command will automatically remove, diagnose, and restore the specified unit.
2.
At MCC, to unconditionally remove the DFI-H, type and enter the following messages:
235-105-210
October 1999
Copyright © 1999
Page 9
Summary of Contents for 5ESS-2000
