Control unit
To voice
terminal jack
OR
To modular voice
terminal extension
cord
Modular voice
terminal cord
OR
To modular voice
terminal jack
FIGURE 6 Connecting the Voice Terminal Cord
10 To remove the voice terminal from the desk stand, set the handset
aside, turn the voice terminal upside down, and unplug the modular
voice terminal cord. Slide the desk stand off the mounting tabs of the
voice terminal.
WALL MOUNT ASSEMBLY
Installing the Wall Mount
1
Break the pieces labeled Desk Support and Wall Support away from
the Base and remove the rough edges where they were attached.
Set aside the desk support piece in case you later decide to mount
your voice terminal on the desk stand. Use a pointed object or the tip
of a screwdriver to remove the four rubber feet in each corner on the
bottom of the base.
2
Place the wall support on a table or desk (Figure 7). Lower the base
over the wall support, inserting the tabs on the wall support into the
slots on the base.
iss 5, cib2853-6
