2-2
APX 1000™ Getting Started Guide
Preparing for Installation
Checking the package contents
can use Telnet to access and configure the system.) The PC or workstation must be set to
the following values:
–
9600bps
–
Direct connection
–
8 data bits
–
No parity
–
1 stop bit
–
No flow control
When connected to the shelf-controller serial port, the PC or workstation acts as a console
terminal through which you can configure the unit.
•
A workstation on a different subnet, from which you can ping the unit to verify the
configuration.
•
The designated IP address for the unit.
•
The designated default gateway for the unit, if your setup requires one.
•
(Optional) A workstation with an Ethernet LAN connection for connecting the unit to the
Ethernet network.
•
Blank single-slot filler cards for any unused slots in the unit.
•
A blank power supply filler card, if the unit is equipped with only a single power supply.
Checking the package contents
APX 1000 package contents vary, depending on the configuration of the unit you order. After
opening the package, verify that you have all the system components that were ordered.
Figure 2-1 shows an APX 1000 shelf.
Figure 2-1. APX 1000 shelf
Verify that the package also contains the following items:
•
Power cable.
•
Personal Computer Memory Card International Association (PCMCIA) cards.
•
Any slot cards you ordered with the system. If you ordered them separately, check the
separate packaging.
•
Mounting hardware with dual-purpose mounting adapters.
If you are missing any items, contact your Lucent sales representative.
