Modular Voice
Terminal Extension Cord
O R
Modular Voice
Terminal
Jack
FIGURE 6 Attaching the Voice Terminal Cord to Building Wiring
12 To remove the voice terminal from the desk stand, unplug the
handset cord. Set the handset aside and turn the voice terminal
over. Unplug the modular voice terminal cord. Press the locking
tab to release it and slide the stand down and away from the voice
terminal.
Wall Mount Installation
1
Break the pieces away from the runner.
2
Locate the pieces labeled BASE and WALL SUPPORT. File the
rough edges off these pieces where they were attached to the
runner. Use the tip of a screwdriver to remove the four rubber feet in
the corners of the bottom of the base.
3
Place the base upside down on a table or desk and insert the tabs
labeled “A” and “B” on the wall support into the slots labeled “A” and
“B” on the base (Figure 7).
iss 4, cib2852-5
