Issue 5 November 2000
363-206-208
End-To-End Installation Tests for Ring Applications of the DDM-2000 OC-12 Multiplexer
Lucent Technologies - Proprietary
See Notice on first page
TID: Each shelf must have a unique TID (Target Identifier).
DSNE: One shelf (and only one shelf) in the network must be set as the
DSNE (Directory Services Network Element).
To
simplify the following test
procedures, temporarily set the first node as both DSNE and AGNE.
Alarm Group: The Alarm Group must be the same (default=255) for each
shelf for complete alarm reporting throughout the network.
AGNE: One shelf in the network (preferably not the shelf that’s directly
connected to the X.25 interface) must be set as the AGNE.
Site NE: Site ID and NE (Network Element) combinations must be unique
in each shelf.
Shelf: Shelf numbers must be unique when shelves are located within the
same bay.
CO/RT: Set Central Office shelves to CO and Remote Terminal shelves to
RT.
TBOS Address: Each shelf should be set to a unique TBOS Address.
TBOS Link: The TBOS Link is for shelves in a CO connected to TBOS. It
prevents failure of a single shelf in a bay from causing a TBOS link failure.
The TBOS primary setting assigns a shelf as a backup for a group of
shelves that share the same TBOS link. The secondary setting provides a
secondary backup. Typically, the shelf cabled to the TBOS is set for PRI-
MARY and the second shelf in the bay is set for secondary. All other
shelves in the CO bay that are associated with that TBOS link are set for
NORMAL. All shelves in the RT are set for NO-TBOS.
TBOS Remote: TBOS Remote allows TBOS to be reported over the
DCC. In order for TBOS to be communicated from an RT, TBOS Remote
must be enabled at both the CO and RT shelves.
(2) For Release 7 shelves, enter the
set-ne
command.
TID: Each shelf must have a unique TID (Target Identifier).
Shelf: Shelf numbers must be unique when shelves are located within the
same bay.
CO/RT: Set Central Office shelves to CO and Remote Terminal shelves to
RT.
Idle: Idle Channel Signal should be set to AIS (default).
(3) Release 5 applications with DDM-2000 OC-3 Release 8 Linear (1+1) exten-
sions should have been provisioned for 1+1 application using the
-
set-oc3
command in the “Stand-Alone (Local) Installation Tests for the DDM-2000 OC-
12 Multiplexer” section of this manual. Otherwise this parameter should have
been left at the 0x1 default setting.
Verify proper provisioning of this parameter by entering the
rtrv-oc3:all;
command.
Summary of Contents for DDM-2000 OC-12
Page 4: ......
Page 370: ...GL 22 Issue 5 June 2000 363 206 208 Glossary ...
Page 382: ...363 206 208 Index 1 ...
